Documentation/devicetree/bindings/serial/st,stm32-usart.txt

   1 * STMicroelectronics STM32 USART
   2
   3 Required properties:
   4 - compatible: can be either:
   5   - "st,stm32-uart",
   6   - "st,stm32f7-uart",
   7   - "st,stm32h7-uart".
   8   depending is compatible with stm32(f4), stm32f7 or stm32h7.
   9 - reg: The address and length of the peripheral registers space
  10 - interrupts:
  11   - The interrupt line for the USART instance,
  12   - An optional wake-up interrupt.
  13 - clocks: The input clock of the USART instance
  14
  15 Optional properties:
  16 - pinctrl: The reference on the pins configuration
  17 - st,hw-flow-ctrl: bool flag to enable hardware flow control.
  18 - rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low,
  19   linux,rs485-enabled-at-boot-time: see rs485.txt.
  20 - dmas: phandle(s) to DMA controller node(s). Refer to stm32-dma.txt
  21 - dma-names: "rx" and/or "tx"
  22
  23 Examples:
  24 usart4: serial@40004c00 {
  25         compatible = "st,stm32-uart";
  26         reg = <0x40004c00 0x400>;
  27         interrupts = <52>;
  28         clocks = <&clk_pclk1>;
  29         pinctrl-names = "default";
  30         pinctrl-0 = <&pinctrl_usart4>;
  31 };
  32
  33 usart2: serial@40004400 {
  34         compatible = "st,stm32-uart";
  35         reg = <0x40004400 0x400>;
  36         interrupts = <38>;
  37         clocks = <&clk_pclk1>;
  38         st,hw-flow-ctrl;
  39         pinctrl-names = "default";
  40         pinctrl-0 = <&pinctrl_usart2 &pinctrl_usart2_rtscts>;
  41 };
  42
  43 usart1: serial@40011000 {
  44         compatible = "st,stm32-uart";
  45         reg = <0x40011000 0x400>;
  46         interrupts = <37>;
  47         clocks = <&rcc 0 164>;
  48         dmas = <&dma2 2 4 0x414 0x0>,
  49                <&dma2 7 4 0x414 0x0>;
  50         dma-names = "rx", "tx";
  51 };