arch/arm64/boot/dts/qcom/pm8916.dtsi

   1 // SPDX-License-Identifier: GPL-2.0
   2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
   3 #include <dt-bindings/input/linux-event-codes.h>
   4 #include <dt-bindings/interrupt-controller/irq.h>
   5 #include <dt-bindings/spmi/spmi.h>
   6
   7 &spmi_bus {
   8
   9         pm8916_0: pmic@0 {
  10                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
  11                 reg = <0x0 SPMI_USID>;
  12                 #address-cells = <1>;
  13                 #size-cells = <0>;
  14
  15                 pon@800 {
  16                         compatible = "qcom,pm8916-pon";
  17                         reg = <0x800>;
  18                         mode-bootloader = <0x2>;
  19                         mode-recovery = <0x1>;
  20
  21                         pwrkey {
  22                                 compatible = "qcom,pm8941-pwrkey";
  23                                 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
  24                                 debounce = <15625>;
  25                                 bias-pull-up;
  26                                 linux,code = <KEY_POWER>;
  27                         };
  28
  29                         pm8916_resin: resin {
  30                                 compatible = "qcom,pm8941-resin";
  31                                 interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
  32                                 debounce = <15625>;
  33                                 bias-pull-up;
  34                                 status = "disabled";
  35                         };
  36
  37                         watchdog {
  38                                 compatible = "qcom,pm8916-wdt";
  39                                 interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
  40                                 timeout-sec = <60>;
  41                         };
  42                 };
  43
  44                 pm8916_charger: charger@1000 {
  45                         compatible = "qcom,pm8916-lbc";
  46                         reg = <0x1000>, <0x1200>, <0x1300>, <0x1600>;
  47                         reg-names = "chgr", "bat_if", "usb", "misc";
  48
  49                         interrupts = <0x0 0x10 0 IRQ_TYPE_EDGE_BOTH>,
  50                                      <0x0 0x10 5 IRQ_TYPE_EDGE_BOTH>,
  51                                      <0x0 0x10 6 IRQ_TYPE_EDGE_BOTH>,
  52                                      <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>,
  53                                      <0x0 0x12 0 IRQ_TYPE_EDGE_BOTH>,
  54                                      <0x0 0x12 1 IRQ_TYPE_EDGE_BOTH>,
  55                                      <0x0 0x13 0 IRQ_TYPE_EDGE_BOTH>,
  56                                      <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>,
  57                                      <0x0 0x13 2 IRQ_TYPE_EDGE_BOTH>,
  58                                      <0x0 0x13 4 IRQ_TYPE_EDGE_BOTH>;
  59                         interrupt-names = "vbat_det",
  60                                           "fast_chg",
  61                                           "chg_fail",
  62                                           "chg_done",
  63                                           "bat_pres",
  64                                           "temp_ok",
  65                                           "coarse_det",
  66                                           "usb_vbus",
  67                                           "chg_gone",
  68                                           "overtemp";
  69
  70                         status = "disabled";
  71                 };
  72
  73                 pm8916_usbin: usb-detect@1300 {
  74                         compatible = "qcom,pm8941-misc";
  75                         reg = <0x1300>;
  76                         interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>;
  77                         interrupt-names = "usb_vbus";
  78                         status = "disabled";
  79                 };
  80
  81                 pm8916_temp: temp-alarm@2400 {
  82                         compatible = "qcom,spmi-temp-alarm";
  83                         reg = <0x2400>;
  84                         interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
  85                         io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
  86                         io-channel-names = "thermal";
  87                         #thermal-sensor-cells = <0>;
  88                 };
  89
  90                 pm8916_vadc: adc@3100 {
  91                         compatible = "qcom,spmi-vadc";
  92                         reg = <0x3100>;
  93                         interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
  94                         #address-cells = <1>;
  95                         #size-cells = <0>;
  96                         #io-channel-cells = <1>;
  97
  98                         channel@0 {
  99                                 reg = <VADC_USBIN>;
 100                                 qcom,pre-scaling = <1 10>;
 101                         };
 102                         channel@7 {
 103                                 reg = <VADC_VSYS>;
 104                                 qcom,pre-scaling = <1 3>;
 105                         };
 106                         channel@8 {
 107                                 reg = <VADC_DIE_TEMP>;
 108                         };
 109                         channel@9 {
 110                                 reg = <VADC_REF_625MV>;
 111                         };
 112                         channel@a {
 113                                 reg = <VADC_REF_1250MV>;
 114                         };
 115                         channel@e {
 116                                 reg = <VADC_GND_REF>;
 117                         };
 118                         channel@f {
 119                                 reg = <VADC_VDD_VADC>;
 120                         };
 121                 };
 122
 123                 pm8916_bms: battery@4000 {
 124                         compatible = "qcom,pm8916-bms-vm";
 125                         reg = <0x4000>;
 126                         interrupts = <0x0 0x40 0 IRQ_TYPE_EDGE_RISING>,
 127                                      <0x0 0x40 1 IRQ_TYPE_EDGE_RISING>,
 128                                      <0x0 0x40 2 IRQ_TYPE_EDGE_RISING>,
 129                                      <0x0 0x40 3 IRQ_TYPE_EDGE_RISING>,
 130                                      <0x0 0x40 4 IRQ_TYPE_EDGE_RISING>,
 131                                      <0x0 0x40 5 IRQ_TYPE_EDGE_RISING>;
 132                         interrupt-names = "cv_leave",
 133                                           "cv_enter",
 134                                           "ocv_good",
 135                                           "ocv_thr",
 136                                           "fifo",
 137                                           "state_chg";
 138
 139                         status = "disabled";
 140                 };
 141
 142                 rtc@6000 {
 143                         compatible = "qcom,pm8941-rtc";
 144                         reg = <0x6000>, <0x6100>;
 145                         reg-names = "rtc", "alarm";
 146                         interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
 147                 };
 148
 149                 pm8916_mpps: mpps@a000 {
 150                         compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
 151                         reg = <0xa000>;
 152                         gpio-controller;
 153                         #gpio-cells = <2>;
 154                         gpio-ranges = <&pm8916_mpps 0 0 4>;
 155                         interrupt-controller;
 156                         #interrupt-cells = <2>;
 157                 };
 158
 159                 pm8916_gpios: gpio@c000 {
 160                         compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
 161                         reg = <0xc000>;
 162                         gpio-controller;
 163                         gpio-ranges = <&pm8916_gpios 0 0 4>;
 164                         #gpio-cells = <2>;
 165                         interrupt-controller;
 166                         #interrupt-cells = <2>;
 167                 };
 168         };
 169
 170         pm8916_1: pmic@1 {
 171                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
 172                 reg = <0x1 SPMI_USID>;
 173                 #address-cells = <1>;
 174                 #size-cells = <0>;
 175
 176                 pm8916_pwm: pwm {
 177                         compatible = "qcom,pm8916-pwm";
 178
 179                         #pwm-cells = <2>;
 180
 181                         status = "disabled";
 182                 };
 183
 184                 pm8916_vib: vibrator@c000 {
 185                         compatible = "qcom,pm8916-vib";
 186                         reg = <0xc000>;
 187                         status = "disabled";
 188                 };
 189
 190                 pm8916_codec: audio-codec@f000 {
 191                         compatible = "qcom,pm8916-wcd-analog-codec";
 192                         reg = <0xf000>;
 193                         interrupt-parent = <&spmi_bus>;
 194                         interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
 195                                      <0x1 0xf0 0x1 IRQ_TYPE_NONE>,
 196                                      <0x1 0xf0 0x2 IRQ_TYPE_NONE>,
 197                                      <0x1 0xf0 0x3 IRQ_TYPE_NONE>,
 198                                      <0x1 0xf0 0x4 IRQ_TYPE_NONE>,
 199                                      <0x1 0xf0 0x5 IRQ_TYPE_NONE>,
 200                                      <0x1 0xf0 0x6 IRQ_TYPE_NONE>,
 201                                      <0x1 0xf0 0x7 IRQ_TYPE_NONE>,
 202                                      <0x1 0xf1 0x0 IRQ_TYPE_NONE>,
 203                                      <0x1 0xf1 0x1 IRQ_TYPE_NONE>,
 204                                      <0x1 0xf1 0x2 IRQ_TYPE_NONE>,
 205                                      <0x1 0xf1 0x3 IRQ_TYPE_NONE>,
 206                                      <0x1 0xf1 0x4 IRQ_TYPE_NONE>,
 207                                      <0x1 0xf1 0x5 IRQ_TYPE_NONE>;
 208                         interrupt-names = "cdc_spk_cnp_int",
 209                                           "cdc_spk_clip_int",
 210                                           "cdc_spk_ocp_int",
 211                                           "mbhc_ins_rem_det1",
 212                                           "mbhc_but_rel_det",
 213                                           "mbhc_but_press_det",
 214                                           "mbhc_ins_rem_det",
 215                                           "mbhc_switch_int",
 216                                           "cdc_ear_ocp_int",
 217                                           "cdc_hphr_ocp_int",
 218                                           "cdc_hphl_ocp_det",
 219                                           "cdc_ear_cnp_int",
 220                                           "cdc_hphr_cnp_int",
 221                                           "cdc_hphl_cnp_int";
 222                         #sound-dai-cells = <1>;
 223                         status = "disabled";
 224                 };
 225         };
 226 };