From c6e633ad916e2af244dbfd11abd2bc077870bdfd Mon Sep 17 00:00:00 2001 From: Daniel Drake Date: Sat, 25 Jun 2011 19:20:11 +0100 Subject: [PATCH] mmc: sdio: reset card during power_restore mmc_sdio_power_restore() skips some steps that are performed in other power-related codepaths which are necessary to fully reset the card. Without this, runtime PM fails for SD8686 SDIO wifi on OLPC XO-1.5. Signed-off-by: Daniel Drake Signed-off-by: Chris Ball --- drivers/mmc/core/sdio.c | 39 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 39 insertions(+) diff --git a/drivers/mmc/core/sdio.c b/drivers/mmc/core/sdio.c index 4d0c15bfa514..262fff019177 100644 --- a/drivers/mmc/core/sdio.c +++ b/drivers/mmc/core/sdio.c @@ -691,15 +691,54 @@ static int mmc_sdio_resume(struct mmc_host *host) static int mmc_sdio_power_restore(struct mmc_host *host) { int ret; + u32 ocr; BUG_ON(!host); BUG_ON(!host->card); mmc_claim_host(host); + + /* + * Reset the card by performing the same steps that are taken by + * mmc_rescan_try_freq() and mmc_attach_sdio() during a "normal" probe. + * + * sdio_reset() is technically not needed. Having just powered up the + * hardware, it should already be in reset state. However, some + * platforms (such as SD8686 on OLPC) do not instantly cut power, + * meaning that a reset is required when restoring power soon after + * powering off. It is harmless in other cases. + * + * The CMD5 reset (mmc_send_io_op_cond()), according to the SDIO spec, + * is not necessary for non-removable cards. However, it is required + * for OLPC SD8686 (which expects a [CMD5,5,3,7] init sequence), and + * harmless in other situations. + * + * With these steps taken, mmc_select_voltage() is also required to + * restore the correct voltage setting of the card. + */ + sdio_reset(host); + mmc_go_idle(host); + mmc_send_if_cond(host, host->ocr_avail); + + ret = mmc_send_io_op_cond(host, 0, &ocr); + if (ret) + goto out; + + if (host->ocr_avail_sdio) + host->ocr_avail = host->ocr_avail_sdio; + + host->ocr = mmc_select_voltage(host, ocr & ~0x7F); + if (!host->ocr) { + ret = -EINVAL; + goto out; + } + ret = mmc_sdio_init_card(host, host->ocr, host->card, mmc_card_keep_power(host)); if (!ret && host->sdio_irqs) mmc_signal_sdio_irq(host); + +out: mmc_release_host(host); return ret; -- 2.34.1