Merge branch 'sparx5-PSFP-support'

Daniel Machon says:

====================
net: Add support for PSFP in Sparx5

================================================================================
Add support for Per-Stream Filtering and Policing (802.1Q-2018, 8.6.5.1).
================================================================================

The VCAP CLM (VCAP IS0 ingress classifier) classifies streams,
identified by ISDX (Ingress Service Index, frame metadata), and maps
ISDX to streams.

Flow meters are also classified by ISDX, and implemented using service
policers (Service Dual Leacky Buckets, SDLB). Leacky buckets are linked
together in a leak chain of a leak group. Leak groups a preconfigured to serve
buckets within a certain rate interval.

Stream gates are time-based policers used by PSFP. Frames are dropped
based on the gate state (OPEN/ CLOSE), whose state will be altered based
on the Gate Control List (GCL) and current PTP time. Apart from
time-based policing, stream gates can alter egress queue selection for
the frames that pass through the Gate. This is done through Internal
Priority Selector (IPS). Stream gates are mapped from stream filters.

Support for tc actions gate and police, have been added to the VCAP IS0 set of
supported actions.

Examples:

// tc filter with gate action
$ tc filter add dev eth1 ingress chain 1100000 prio 1 handle 1001 protocol \
802.1q flower skip_sw vlan_id 100 action gate base-time 0 sched-entry open \
700000 7 8m sched-entry close 300000 action goto chain 1200000

// tc filter with police action
$ tc filter add dev eth1 ingress chain 1100000 prio 1 handle 1002 protocol \
802.1q flower skip_sw vlan_id 100 action police rate 1gbit burst 8096      \
conform-exceed drop action goto chain 1200000

================================================================================
Patches
================================================================================
Patch #1:  Adds new register needed for PSFP.
Patch #2:  Adds resource pools to control PSFP needed chip resources.
Patch #3:  Adds support for SDLB's needed for flow-meters.
Patch #4:  Adds support for service policers.
Patch #5:  Adds support for PSFP flow-meters, using service policers.
Patch #6:  Adds a new function to calculate basetime, required by flow-meters.
Patch #7:  Adds support for PSFP stream gates.
Patch #8:  Adds support for PSFP stream filters.
Patch #9:  Adds a function to initialize flow-meters, stream gates and stream
           filters.
Patch #10: Adds the required flower code to configure PSFP using the tc command.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>