void __iomem *ctl_block;
void __iomem *gen_block;
void __iomem *notifier_clear_block;
+ u64 adma_dma_mask;
u8 flags;
int last_issue_ncq;
};
{
struct ata_port *ap = ata_shost_to_port(sdev->host);
struct nv_adma_port_priv *pp = ap->private_data;
+ struct nv_adma_port_priv *port0, *port1;
+ struct scsi_device *sdev0, *sdev1;
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
- u64 bounce_limit;
- unsigned long segment_boundary;
+ unsigned long segment_boundary, flags;
unsigned short sg_tablesize;
int rc;
int adma_enable;
/* Not a proper libata device, ignore */
return rc;
+ spin_lock_irqsave(ap->lock, flags);
+
if (ap->link.device[sdev->id].class == ATA_DEV_ATAPI) {
/*
* NVIDIA reports that ADMA mode does not support ATAPI commands.
* Restrict DMA parameters as required by the legacy interface
* when an ATAPI device is connected.
*/
- bounce_limit = ATA_DMA_MASK;
segment_boundary = ATA_DMA_BOUNDARY;
/* Subtract 1 since an extra entry may be needed for padding, see
libata-scsi.c */
adma_enable = 0;
nv_adma_register_mode(ap);
} else {
- bounce_limit = *ap->dev->dma_mask;
segment_boundary = NV_ADMA_DMA_BOUNDARY;
sg_tablesize = NV_ADMA_SGTBL_TOTAL_LEN;
adma_enable = 1;
if (current_reg != new_reg)
pci_write_config_dword(pdev, NV_MCP_SATA_CFG_20, new_reg);
- blk_queue_bounce_limit(sdev->request_queue, bounce_limit);
+ port0 = ap->host->ports[0]->private_data;
+ port1 = ap->host->ports[1]->private_data;
+ sdev0 = ap->host->ports[0]->link.device[0].sdev;
+ sdev1 = ap->host->ports[1]->link.device[0].sdev;
+ if ((port0->flags & NV_ADMA_ATAPI_SETUP_COMPLETE) ||
+ (port1->flags & NV_ADMA_ATAPI_SETUP_COMPLETE)) {
+ /** We have to set the DMA mask to 32-bit if either port is in
+ ATAPI mode, since they are on the same PCI device which is
+ used for DMA mapping. If we set the mask we also need to set
+ the bounce limit on both ports to ensure that the block
+ layer doesn't feed addresses that cause DMA mapping to
+ choke. If either SCSI device is not allocated yet, it's OK
+ since that port will discover its correct setting when it
+ does get allocated.
+ Note: Setting 32-bit mask should not fail. */
+ if (sdev0)
+ blk_queue_bounce_limit(sdev0->request_queue,
+ ATA_DMA_MASK);
+ if (sdev1)
+ blk_queue_bounce_limit(sdev1->request_queue,
+ ATA_DMA_MASK);
+
+ pci_set_dma_mask(pdev, ATA_DMA_MASK);
+ } else {
+ /** This shouldn't fail as it was set to this value before */
+ pci_set_dma_mask(pdev, pp->adma_dma_mask);
+ if (sdev0)
+ blk_queue_bounce_limit(sdev0->request_queue,
+ pp->adma_dma_mask);
+ if (sdev1)
+ blk_queue_bounce_limit(sdev1->request_queue,
+ pp->adma_dma_mask);
+ }
+
blk_queue_segment_boundary(sdev->request_queue, segment_boundary);
blk_queue_max_hw_segments(sdev->request_queue, sg_tablesize);
ata_port_printk(ap, KERN_INFO,
- "bounce limit 0x%llX, segment boundary 0x%lX, hw segs %hu\n",
- (unsigned long long)bounce_limit, segment_boundary, sg_tablesize);
+ "DMA mask 0x%llX, segment boundary 0x%lX, hw segs %hu\n",
+ (unsigned long long)*ap->host->dev->dma_mask,
+ segment_boundary, sg_tablesize);
+
+ spin_unlock_irqrestore(ap->lock, flags);
+
return rc;
}
}
if (status & (NV_ADMA_STAT_DONE |
- NV_ADMA_STAT_CPBERR)) {
- u32 check_commands;
+ NV_ADMA_STAT_CPBERR |
+ NV_ADMA_STAT_CMD_COMPLETE)) {
+ u32 check_commands = notifier_clears[i];
int pos, error = 0;
- if (ata_tag_valid(ap->link.active_tag))
- check_commands = 1 << ap->link.active_tag;
- else
- check_commands = ap->link.sactive;
+ if (status & NV_ADMA_STAT_CPBERR) {
+ /* Check all active commands */
+ if (ata_tag_valid(ap->link.active_tag))
+ check_commands = 1 <<
+ ap->link.active_tag;
+ else
+ check_commands = ap->
+ link.sactive;
+ }
/** Check CPBs for completed commands */
while ((pos = ffs(check_commands)) && !error) {
void *mem;
dma_addr_t mem_dma;
void __iomem *mmio;
+ struct pci_dev *pdev = to_pci_dev(dev);
u16 tmp;
VPRINTK("ENTER\n");
+ /* Ensure DMA mask is set to 32-bit before allocating legacy PRD and
+ pad buffers */
+ rc = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
+ if (rc)
+ return rc;
+ rc = pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32));
+ if (rc)
+ return rc;
+
rc = ata_port_start(ap);
if (rc)
return rc;
pp->notifier_clear_block = pp->gen_block +
NV_ADMA_NOTIFIER_CLEAR + (4 * ap->port_no);
+ /* Now that the legacy PRD and padding buffer are allocated we can
+ safely raise the DMA mask to allocate the CPB/APRD table.
+ These are allowed to fail since we store the value that ends up
+ being used to set as the bounce limit in slave_config later if
+ needed. */
+ pci_set_dma_mask(pdev, DMA_BIT_MASK(64));
+ pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(64));
+ pp->adma_dma_mask = *dev->dma_mask;
+
mem = dmam_alloc_coherent(dev, NV_ADMA_PORT_PRIV_DMA_SZ,
&mem_dma, GFP_KERNEL);
if (!mem)
hpriv->type = type;
host->private_data = hpriv;
- /* set 64bit dma masks, may fail */
- if (type == ADMA) {
- if (pci_set_dma_mask(pdev, DMA_64BIT_MASK) == 0)
- pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK);
- }
-
/* request and iomap NV_MMIO_BAR */
rc = pcim_iomap_regions(pdev, 1 << NV_MMIO_BAR, DRV_NAME);
if (rc)
git.samba.org / sfrench / cifs-2.6.git / blobdiff