*((volatile uint *)BCSR1) &= ~BCSR1_ETHEN;
#endif
-#ifdef CONFIG_MPC885ADS
-
- /* Deassert PHY reset and enable the PHY.
- */
- {
- volatile uint __iomem *bcsr = ioremap(BCSR_ADDR, BCSR_SIZE);
- uint tmp;
-
- tmp = in_be32(bcsr + 1 /* BCSR1 */);
- tmp |= BCSR1_ETHEN;
- out_be32(bcsr + 1, tmp);
- tmp = in_be32(bcsr + 4 /* BCSR4 */);
- tmp |= BCSR4_ETH10_RST;
- out_be32(bcsr + 4, tmp);
- iounmap(bcsr);
- }
-
- /* On MPC885ADS SCC ethernet PHY defaults to the full duplex mode
- * upon reset. SCC is set to half duplex by default. So this
- * inconsistency should be better fixed by the software.
- */
-#endif
-
dev->base_addr = (unsigned long)ep;
#if 0
dev->name = "CPM_ENET";