bool "Ethernet support"
depends on ETRAX_ARCH_V10
select NET_ETHERNET
+ select MII
help
This option enables the ETRAX 100LX built-in 10/100Mbit Ethernet
controller.
loopback. Not all products are able to do this in software only.
Axis 2400/2401 must disable receiver.
-config ETRAX_IDE
- bool "ATA/IDE support"
- select IDE
- select BLK_DEV_IDE
- select BLK_DEV_IDEDISK
- select BLK_DEV_IDECD
- select BLK_DEV_IDEDMA
- help
- Enable this to get support for ATA/IDE.
- You can't use parallel ports or SCSI ports
- at the same time.
-
-
-config ETRAX_IDE_DELAY
- int "Delay for drives to regain consciousness"
- depends on ETRAX_IDE
- default 15
- help
- Number of seconds to wait for IDE drives to spin up after an IDE
- reset.
-choice
- prompt "IDE reset pin"
- depends on ETRAX_IDE
- default ETRAX_IDE_PB7_RESET
-
-config ETRAX_IDE_PB7_RESET
- bool "Port_PB_Bit_7"
- help
- IDE reset on pin 7 on port B
-
-config ETRAX_IDE_G27_RESET
- bool "Port_G_Bit_27"
- help
- IDE reset on pin 27 on port G
-
-endchoice
-
-
config ETRAX_USB_HOST
bool "USB host"
select USB
select MTD
select MTD_CFI
select MTD_CFI_AMDSTD
- select MTD_OBSOLETE_CHIPS
- select MTD_AMDSTD
select MTD_CHAR
select MTD_BLOCK
select MTD_PARTITIONS