Merge branch 'bkl-removal' of git://git.lwn.net/linux-2.6

[sfrench/cifs-2.6.git] / arch / arm / mach-at91 / board-qil-a9260.c

diff --git a/arch/arm/mach-at91/board-qil-a9260.c b/arch/arm/mach-at91/board-qil-a9260.c
index cfb4571a2e275d00c52a587a8ed21d71d9d7b59a..4cff9a7e61d2d70b8af645e11bc38df30bfdd72a 100644 (file)
--- a/arch/arm/mach-at91/board-qil-a9260.c
+++ b/arch/arm/mach-at91/board-qil-a9260.c
@@ -41,8 +41,10 @@
 #include <mach/hardware.h>
 #include <mach/board.h>
 #include <mach/gpio.h>
+#include <mach/at91sam9_smc.h>
 #include <mach/at91_shdwc.h>
 
+#include "sam9_smc.h"
 #include "generic.h"
 
 
@@ -147,13 +149,34 @@ static struct atmel_nand_data __initdata ek_nand_data = {
        .rdy_pin        = AT91_PIN_PC13,
        .enable_pin     = AT91_PIN_PC14,
        .partition_info = nand_partitions,
-#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
-       .bus_width_16   = 1,
-#else
-       .bus_width_16   = 0,
-#endif
 };
 
+static struct sam9_smc_config __initdata ek_nand_smc_config = {
+       .ncs_read_setup         = 0,
+       .nrd_setup              = 1,
+       .ncs_write_setup        = 0,
+       .nwe_setup              = 1,
+
+       .ncs_read_pulse         = 3,
+       .nrd_pulse              = 3,
+       .ncs_write_pulse        = 3,
+       .nwe_pulse              = 3,
+
+       .read_cycle             = 5,
+       .write_cycle            = 5,
+
+       .mode                   = AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE | AT91_SMC_DBW_8,
+       .tdf_cycles             = 2,
+};
+
+static void __init ek_add_device_nand(void)
+{
+       /* configure chip-select 3 (NAND) */
+       sam9_smc_configure(3, &ek_nand_smc_config);
+
+       at91_add_device_nand(&ek_nand_data);
+}
+
 /*
  * MCI (SD/MMC)
  */
@@ -227,7 +250,7 @@ static void __init ek_board_init(void)
        /* SPI */
        at91_add_device_spi(ek_spi_devices, ARRAY_SIZE(ek_spi_devices));
        /* NAND */
-       at91_add_device_nand(&ek_nand_data);
+       ek_add_device_nand();
        /* I2C */
        at91_add_device_i2c(NULL, 0);
        /* Ethernet */