1 Renesas Electronics USBHS driver
4 - compatible: Must contain one or more of the following:
6 - "renesas,usbhs-r8a7743" for r8a7743 (RZ/G1M) compatible device
7 - "renesas,usbhs-r8a7745" for r8a7745 (RZ/G1E) compatible device
8 - "renesas,usbhs-r8a7790" for r8a7790 (R-Car H2) compatible device
9 - "renesas,usbhs-r8a7791" for r8a7791 (R-Car M2-W) compatible device
10 - "renesas,usbhs-r8a7792" for r8a7792 (R-Car V2H) compatible device
11 - "renesas,usbhs-r8a7793" for r8a7793 (R-Car M2-N) compatible device
12 - "renesas,usbhs-r8a7794" for r8a7794 (R-Car E2) compatible device
13 - "renesas,usbhs-r8a7795" for r8a7795 (R-Car H3) compatible device
14 - "renesas,usbhs-r8a7796" for r8a7796 (R-Car M3-W) compatible device
15 - "renesas,usbhs-r8a77995" for r8a77995 (R-Car D3) compatible device
16 - "renesas,rcar-gen2-usbhs" for R-Car Gen2 or RZ/G1 compatible devices
17 - "renesas,rcar-gen3-usbhs" for R-Car Gen3 compatible device
19 When compatible with the generic version, nodes must list the
20 SoC-specific version corresponding to the platform first followed
21 by the generic version.
23 - reg: Base address and length of the register for the USBHS
24 - interrupts: Interrupt specifier for the USBHS
25 - clocks: A list of phandle + clock specifier pairs
28 - renesas,buswait: Integer to use BUSWAIT register
29 - renesas,enable-gpio: A gpio specifier to check GPIO determining if USB
30 function should be enabled
31 - phys: phandle + phy specifier pair
32 - phy-names: must be "usb"
33 - dmas: Must contain a list of references to DMA specifiers.
34 - dma-names : named "ch%d", where %d is the channel number ranging from zero
35 to the number of channels (DnFIFOs) minus one.
39 compatible = "renesas,usbhs-r8a7790", "renesas,rcar-gen2-usbhs";
40 reg = <0 0xe6590000 0 0x100>;
41 interrupts = <0 107 IRQ_TYPE_LEVEL_HIGH>;
42 clocks = <&mstp7_clks R8A7790_CLK_HSUSB>;