Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt

   1 Qualcomm Hexagon Peripheral Image Loader
   2
   3 This document defines the binding for a component that loads and boots firmware
   4 on the Qualcomm Hexagon core.
   5
   6 - compatible:
   7         Usage: required
   8         Value type: <string>
   9         Definition: must be one of:
  10                     "qcom,q6v5-pil",
  11                     "qcom,msm8916-mss-pil",
  12                     "qcom,msm8974-mss-pil"
  13
  14 - reg:
  15         Usage: required
  16         Value type: <prop-encoded-array>
  17         Definition: must specify the base address and size of the qdsp6 and
  18                     rmb register blocks
  19
  20 - reg-names:
  21         Usage: required
  22         Value type: <stringlist>
  23         Definition: must be "q6dsp" and "rmb"
  24
  25 - interrupts-extended:
  26         Usage: required
  27         Value type: <prop-encoded-array>
  28         Definition: must list the watchdog, fatal IRQs ready, handover and
  29                     stop-ack IRQs
  30
  31 - interrupt-names:
  32         Usage: required
  33         Value type: <stringlist>
  34         Definition: must be "wdog", "fatal", "ready", "handover", "stop-ack"
  35
  36 - clocks:
  37         Usage: required
  38         Value type: <phandle>
  39         Definition: reference to the iface, bus and mem clocks to be held on
  40                     behalf of the booting of the Hexagon core
  41
  42 - clock-names:
  43         Usage: required
  44         Value type: <stringlist>
  45         Definition: must be "iface", "bus", "mem"
  46
  47 - resets:
  48         Usage: required
  49         Value type: <phandle>
  50         Definition: reference to the reset-controller for the modem sub-system
  51
  52 - reset-names:
  53         Usage: required
  54         Value type: <stringlist>
  55         Definition: must be "mss_restart"
  56
  57 - cx-supply:
  58 - mss-supply:
  59 - mx-supply:
  60 - pll-supply:
  61         Usage: required
  62         Value type: <phandle>
  63         Definition: reference to the regulators to be held on behalf of the
  64                     booting of the Hexagon core
  65
  66 - qcom,smem-states:
  67         Usage: required
  68         Value type: <phandle>
  69         Definition: reference to the smem state for requesting the Hexagon to
  70                     shut down
  71
  72 - qcom,smem-state-names:
  73         Usage: required
  74         Value type: <stringlist>
  75         Definition: must be "stop"
  76
  77 - qcom,halt-regs:
  78         Usage: required
  79         Value type: <prop-encoded-array>
  80         Definition: a phandle reference to a syscon representing TCSR followed
  81                     by the three offsets within syscon for q6, modem and nc
  82                     halt registers.
  83
  84 = SUBNODES:
  85 The Hexagon node must contain two subnodes, named "mba" and "mpss" representing
  86 the memory regions used by the Hexagon firmware. Each sub-node must contain:
  87
  88 - memory-region:
  89         Usage: required
  90         Value type: <phandle>
  91         Definition: reference to the reserved-memory for the region
  92
  93 = EXAMPLE
  94 The following example describes the resources needed to boot control the
  95 Hexagon, as it is found on MSM8974 boards.
  96
  97         modem-rproc@fc880000 {
  98                 compatible = "qcom,q6v5-pil";
  99                 reg = <0xfc880000 0x100>,
 100                       <0xfc820000 0x020>;
 101                 reg-names = "qdsp6", "rmb";
 102
 103                 interrupts-extended = <&intc 0 24 1>,
 104                                       <&modem_smp2p_in 0 0>,
 105                                       <&modem_smp2p_in 1 0>,
 106                                       <&modem_smp2p_in 2 0>,
 107                                       <&modem_smp2p_in 3 0>;
 108                 interrupt-names = "wdog",
 109                                   "fatal",
 110                                   "ready",
 111                                   "handover",
 112                                   "stop-ack";
 113
 114                 clocks = <&gcc GCC_MSS_Q6_BIMC_AXI_CLK>,
 115                          <&gcc GCC_MSS_CFG_AHB_CLK>,
 116                          <&gcc GCC_BOOT_ROM_AHB_CLK>;
 117                 clock-names = "iface", "bus", "mem";
 118
 119                 qcom,halt-regs = <&tcsr_mutex_block 0x1180 0x1200 0x1280>;
 120
 121                 resets = <&gcc GCC_MSS_RESTART>;
 122                 reset-names = "mss_restart";
 123
 124                 cx-supply = <&pm8841_s2>;
 125                 mss-supply = <&pm8841_s3>;
 126                 mx-supply = <&pm8841_s1>;
 127                 pll-supply = <&pm8941_l12>;
 128
 129                 qcom,smem-states = <&modem_smp2p_out 0>;
 130                 qcom,smem-state-names = "stop";
 131
 132                 mba {
 133                         memory-region = <&mba_region>;
 134                 };
 135
 136                 mpss {
 137                         memory-region = <&mpss_region>;
 138                 };
 139         };