Documentation/devicetree/bindings/regulator/s5m8767-regulator.txt

   1 * Samsung S5M8767 Voltage and Current Regulator
   2
   3 The Samsung S5M8767 is a multi-function device which includes voltage and
   4 current regulators, rtc, charger controller and other sub-blocks. It is
   5 interfaced to the host controller using a i2c interface. Each sub-block is
   6 addressed by the host system using different i2c slave address. This document
   7 describes the bindings for 'pmic' sub-block of s5m8767.
   8
   9 Required properties:
  10 - compatible: Should be "samsung,s5m8767-pmic".
  11 - reg: Specifies the i2c slave address of the pmic block. It should be 0x66.
  12
  13 - s5m8767,pmic-buck2-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
  14   units for buck2 when changing voltage using gpio dvs. Refer to [1] below
  15   for additional information.
  16
  17 - s5m8767,pmic-buck3-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
  18   units for buck3 when changing voltage using gpio dvs. Refer to [1] below
  19   for additional information.
  20
  21 - s5m8767,pmic-buck4-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
  22   units for buck4 when changing voltage using gpio dvs. Refer to [1] below
  23   for additional information.
  24
  25 - s5m8767,pmic-buck-ds-gpios: GPIO specifiers for three host gpio's used
  26   for selecting GPIO DVS lines. It is one-to-one mapped to dvs gpio lines.
  27
  28 [1] If none of the 's5m8767,pmic-buck[2/3/4]-uses-gpio-dvs' optional
  29     property is specified, the 's5m8767,pmic-buck[2/3/4]-dvs-voltage'
  30     property should specify atleast one voltage level (which would be a
  31     safe operating voltage).
  32
  33     If either of the 's5m8767,pmic-buck[2/3/4]-uses-gpio-dvs' optional
  34     property is specified, then all the eight voltage values for the
  35     's5m8767,pmic-buck[2/3/4]-dvs-voltage' should be specified.
  36
  37 Optional properties:
  38 - interrupt-parent: Specifies the phandle of the interrupt controller to which
  39   the interrupts from s5m8767 are delivered to.
  40 - interrupts: Interrupt specifiers for two interrupt sources.
  41   - First interrupt specifier is for 'irq1' interrupt.
  42   - Second interrupt specifier is for 'alert' interrupt.
  43 - s5m8767,pmic-buck2-uses-gpio-dvs: 'buck2' can be controlled by gpio dvs.
  44 - s5m8767,pmic-buck3-uses-gpio-dvs: 'buck3' can be controlled by gpio dvs.
  45 - s5m8767,pmic-buck4-uses-gpio-dvs: 'buck4' can be controlled by gpio dvs.
  46
  47 Additional properties required if either of the optional properties are used:
  48
  49 - s5m8767,pmic-buck234-default-dvs-idx: Default voltage setting selected from
  50   the possible 8 options selectable by the dvs gpios. The value of this
  51   property should be between 0 and 7. If not specified or if out of range, the
  52   default value of this property is set to 0.
  53
  54 - s5m8767,pmic-buck-dvs-gpios: GPIO specifiers for three host gpio's used
  55   for dvs. The format of the gpio specifier depends in the gpio controller.
  56
  57 Regulators: The regulators of s5m8767 that have to be instantiated should be
  58 included in a sub-node named 'regulators'. Regulator nodes included in this
  59 sub-node should be of the format as listed below.
  60
  61         regulator_name {
  62                 ldo1_reg: LDO1 {
  63                         regulator-name = "VDD_ALIVE_1.0V";
  64                         regulator-min-microvolt = <1100000>;
  65                         regulator-max-microvolt = <1100000>;
  66                         regulator-always-on;
  67                         regulator-boot-on;
  68                         op_mode = <1>; /* Normal Mode */
  69                 };
  70         };
  71 The above regulator entries are defined in regulator bindings documentation
  72 except these properties:
  73         - op_mode: describes the different operating modes of the LDO's with
  74                 power mode change in SOC. The different possible values are,
  75                 0 - always off mode
  76                 1 - on in normal mode
  77                 2 - low power mode
  78                 3 - suspend mode
  79         - s5m8767,pmic-ext-control-gpios: (optional) GPIO specifier for one
  80                 GPIO controlling this regulator (enable/disable); This is
  81                 valid only for buck9.
  82
  83 The following are the names of the regulators that the s5m8767 pmic block
  84 supports. Note: The 'n' in LDOn and BUCKn represents the LDO or BUCK number
  85 as per the datasheet of s5m8767.
  86
  87         - LDOn
  88                   - valid values for n are 1 to 28
  89                   - Example: LDO1, LDO2, LDO28
  90         - BUCKn
  91                   - valid values for n are 1 to 9.
  92                   - Example: BUCK1, BUCK2, BUCK9
  93
  94 The bindings inside the regulator nodes use the standard regulator bindings
  95 which are documented elsewhere.
  96
  97 Example:
  98
  99         s5m8767_pmic@66 {
 100                 compatible = "samsung,s5m8767-pmic";
 101                 reg = <0x66>;
 102
 103                 s5m8767,pmic-buck2-uses-gpio-dvs;
 104                 s5m8767,pmic-buck3-uses-gpio-dvs;
 105                 s5m8767,pmic-buck4-uses-gpio-dvs;
 106
 107                 s5m8767,pmic-buck-default-dvs-idx = <0>;
 108
 109                 s5m8767,pmic-buck-dvs-gpios = <&gpx0 0 0>, /* DVS1 */
 110                                                  <&gpx0 1 0>, /* DVS2 */
 111                                                  <&gpx0 2 0>; /* DVS3 */
 112
 113                 s5m8767,pmic-buck-ds-gpios = <&gpx2 3 0>, /* SET1 */
 114                                                 <&gpx2 4 0>, /* SET2 */
 115                                                 <&gpx2 5 0>; /* SET3 */
 116
 117                 s5m8767,pmic-buck2-dvs-voltage = <1350000>, <1300000>,
 118                                                  <1250000>, <1200000>,
 119                                                  <1150000>, <1100000>,
 120                                                  <1000000>, <950000>;
 121
 122                 s5m8767,pmic-buck3-dvs-voltage = <1100000>, <1100000>,
 123                                                  <1100000>, <1100000>,
 124                                                  <1000000>, <1000000>,
 125                                                  <1000000>, <1000000>;
 126
 127                 s5m8767,pmic-buck4-dvs-voltage = <1200000>, <1200000>,
 128                                                  <1200000>, <1200000>,
 129                                                  <1200000>, <1200000>,
 130                                                  <1200000>, <1200000>;
 131
 132                 regulators {
 133                         ldo1_reg: LDO1 {
 134                                 regulator-name = "VDD_ABB_3.3V";
 135                                 regulator-min-microvolt = <3300000>;
 136                                 regulator-max-microvolt = <3300000>;
 137                                 op_mode = <1>; /* Normal Mode */
 138                         };
 139
 140                         ldo2_reg: LDO2 {
 141                                 regulator-name = "VDD_ALIVE_1.1V";
 142                                 regulator-min-microvolt = <1100000>;
 143                                 regulator-max-microvolt = <1100000>;
 144                                 regulator-always-on;
 145                         };
 146
 147                         buck1_reg: BUCK1 {
 148                                 regulator-name = "VDD_MIF_1.2V";
 149                                 regulator-min-microvolt = <950000>;
 150                                 regulator-max-microvolt = <1350000>;
 151                                 regulator-always-on;
 152                                 regulator-boot-on;
 153                         };
 154
 155                         vemmc_reg: BUCK9 {
 156                                 regulator-name = "VMEM_VDD_2.8V";
 157                                 regulator-min-microvolt = <2800000>;
 158                                 regulator-max-microvolt = <2800000>;
 159                                 op_mode = <3>; /* Standby Mode */
 160                                 s5m8767,pmic-ext-control-gpios = <&gpk0 2 0>;
 161                         };
 162                 };
 163         };