Documentation/devicetree/bindings/net/btusb.txt

   1 Generic Bluetooth controller over USB (btusb driver)
   2 ---------------------------------------------------
   3
   4 Required properties:
   5
   6   - compatible : should comply with the format "usbVID,PID" specified in
   7                  Documentation/devicetree/bindings/usb/usb-device.txt
   8                  At the time of writing, the only OF supported devices
   9                  (more may be added later) are:
  10
  11                   "usb1286,204e" (Marvell 8997)
  12
  13 Also, vendors that use btusb may have device additional properties, e.g:
  14 Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt
  15
  16 Optional properties:
  17
  18   - interrupt-names: (see below)
  19   - interrupts : The interrupt specified by the name "wakeup" is the interrupt
  20                  that shall be used for out-of-band wake-on-bt. Driver will
  21                  request this interrupt for wakeup. During system suspend, the
  22                  irq will be enabled so that the bluetooth chip can wakeup host
  23                  platform out of band. During system resume, the irq will be
  24                  disabled to make sure unnecessary interrupt is not received.
  25
  26 Example:
  27
  28 Following example uses irq pin number 3 of gpio0 for out of band wake-on-bt:
  29
  30 &usb_host1_ehci {
  31     #address-cells = <1>;
  32     #size-cells = <0>;
  33
  34     mvl_bt1: bt@1 {
  35         compatible = "usb1286,204e";
  36         reg = <1>;
  37         interrupt-parent = <&gpio0>;
  38         interrupt-name = "wakeup";
  39         interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
  40     };
  41 };