return ERR_PTR(err);
}
+static const struct net_device_ops seeq8005_netdev_ops = {
+ .ndo_open = seeq8005_open,
+ .ndo_stop = seeq8005_close,
+ .ndo_start_xmit = seeq8005_send_packet,
+ .ndo_tx_timeout = seeq8005_timeout,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probes avoids doing writes, and
verifies that the correct device exists and functions. */
int old_dmaar;
int old_rear;
int retval;
- DECLARE_MAC_BUF(mac);
if (!request_region(ioaddr, SEEQ8005_IO_EXTENT, "seeq8005"))
return -ENODEV;
/* Retrieve and print the ethernet address. */
for (i = 0; i < 6; i++)
dev->dev_addr[i] = SA_prom[i+6];
- printk("%s", print_mac(mac, dev->dev_addr));
+ printk("%pM", dev->dev_addr);
if (dev->irq == 0xff)
; /* Do nothing: a user-level program will set it. */
}
}
#endif
- dev->open = seeq8005_open;
- dev->stop = seeq8005_close;
- dev->hard_start_xmit = seeq8005_send_packet;
- dev->tx_timeout = seeq8005_timeout;
+ dev->netdev_ops = &seeq8005_netdev_ops;
dev->watchdog_timeo = HZ/20;
- dev->set_multicast_list = set_multicast_list;
dev->flags &= ~IFF_MULTICAST;
return 0;
skb->protocol=eth_type_trans(skb,dev);
netif_rx(skb);
- dev->last_rx = jiffies;
dev->stats.rx_packets++;
dev->stats.rx_bytes += pkt_len;
}
}
#endif /* MODULE */
-
-/*
- * Local variables:
- * compile-command: "gcc -D__KERNEL__ -I/usr/src/linux/net/inet -Wall -Wstrict-prototypes -O6 -m486 -c skeleton.c"
- * version-control: t
- * kept-new-versions: 5
- * tab-width: 4
- * End:
- */