static void gfar_set_multi(struct net_device *dev);
static void gfar_set_hash_for_addr(struct net_device *dev, u8 *addr);
static void gfar_configure_serdes(struct net_device *dev);
-extern int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id, int regnum, u16 value);
-extern int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum);
#ifdef CONFIG_GFAR_NAPI
static int gfar_poll(struct napi_struct *napi, int budget);
#endif
static void gfar_netpoll(struct net_device *dev);
#endif
int gfar_clean_rx_ring(struct net_device *dev, int rx_work_limit);
+static int gfar_clean_tx_ring(struct net_device *dev);
static int gfar_process_frame(struct net_device *dev, struct sk_buff *skb, int length);
static void gfar_vlan_rx_register(struct net_device *netdev,
struct vlan_group *grp);
return 0;
}
+/*
+ * Initialize TBI PHY interface for communicating with the
+ * SERDES lynx PHY on the chip. We communicate with this PHY
+ * through the MDIO bus on each controller, treating it as a
+ * "normal" PHY at the address found in the TBIPA register. We assume
+ * that the TBIPA register is valid. Either the MDIO bus code will set
+ * it to a value that doesn't conflict with other PHYs on the bus, or the
+ * value doesn't matter, as there are no other PHYs on the bus.
+ */
static void gfar_configure_serdes(struct net_device *dev)
{
struct gfar_private *priv = netdev_priv(dev);
struct gfar_mii __iomem *regs =
(void __iomem *)&priv->regs->gfar_mii_regs;
+ int tbipa = gfar_read(&priv->regs->tbipa);
- /* Initialise TBI i/f to communicate with serdes (lynx phy) */
-
- /* Single clk mode, mii mode off(for aerdes communication) */
- gfar_local_mdio_write(regs, TBIPA_VALUE, MII_TBICON, TBICON_CLK_SELECT);
+ /* Single clk mode, mii mode off(for serdes communication) */
+ gfar_local_mdio_write(regs, tbipa, MII_TBICON, TBICON_CLK_SELECT);
- /* Supported pause and full-duplex, no half-duplex */
- gfar_local_mdio_write(regs, TBIPA_VALUE, MII_ADVERTISE,
+ gfar_local_mdio_write(regs, tbipa, MII_ADVERTISE,
ADVERTISE_1000XFULL | ADVERTISE_1000XPAUSE |
ADVERTISE_1000XPSE_ASYM);
- /* ANEG enable, restart ANEG, full duplex mode, speed[1] set */
- gfar_local_mdio_write(regs, TBIPA_VALUE, MII_BMCR, BMCR_ANENABLE |
+ gfar_local_mdio_write(regs, tbipa, MII_BMCR, BMCR_ANENABLE |
BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000);
}
/* Initialize the Minimum Frame Length Register */
gfar_write(&priv->regs->minflr, MINFLR_INIT_SETTINGS);
-
- /* Assign the TBI an address which won't conflict with the PHYs */
- gfar_write(&priv->regs->tbipa, TBIPA_VALUE);
}
dev_kfree_skb_any(priv->tx_skbuff[i]);
priv->tx_skbuff[i] = NULL;
}
+
+ txbdp++;
}
kfree(priv->tx_skbuff);
}
/* Changes the mac address if the controller is not running. */
-int gfar_set_mac_address(struct net_device *dev)
+static int gfar_set_mac_address(struct net_device *dev)
{
gfar_set_mac_for_addr(dev, 0, dev->dev_addr);
}
/* Interrupt Handler for Transmit complete */
-int gfar_clean_tx_ring(struct net_device *dev)
+static int gfar_clean_tx_ring(struct net_device *dev)
{
struct txbd8 *bdp;
struct gfar_private *priv = netdev_priv(dev);