ARM: dts: imx6qdl-colibri: use pull-down on wake-up pin

The wake-up pin is pulled low with 100kOhm on the carrier board.
The current configuration of 100kOhm pull-up caused lots of
interrupts, especially during boot up. Make sure the pin is at a
reasonable level at startup by pulling it low on SoC side too.

Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

diff --git a/arch/arm/boot/dts/imx6qdl-colibri.dtsi b/arch/arm/boot/dts/imx6qdl-colibri.dtsi
index 55c90c2fbf69747d5f84e9939f7c8274834992f1..6e937ca20869c989c802bde9ab606b8aee025b21 100644 (file)
--- a/arch/arm/boot/dts/imx6qdl-colibri.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-colibri.dtsi
@@ -480,8 +480,7 @@
 
        pinctrl_gpio_keys: gpiokeys {
                fsl,pins = <
-                       /* Power button */
-                       MX6QDL_PAD_EIM_A16__GPIO2_IO22          0x1b0b0
+                       MX6QDL_PAD_EIM_A16__GPIO2_IO22          0x130b0
                >;
        };