Merge tag 'tty-5.1-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty

Merge tag 'tty-5.1-rc1' of git://git./linux/kernel/git/gregkh/tty

Pull tty/serial updates from Greg KH:
 "Here is the "big" patchset for the tty/serial driver layer for
  5.1-rc1.

  It's really not all that big, nothing major here.

  There are a lot of tiny driver fixes and updates, combined with other
  cleanups for different serial drivers and the vt layer. Full details
  are in the shortlog.

  All of these have been in linux-next with no reported issues"

* tag 'tty-5.1-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty: (70 commits)
  tty: xilinx_uartps: Correct return value in probe
  serial: sprd: Modify the baud rate calculation formula
  dt-bindings: serial: Add Milbeaut serial driver description
  serial: 8250_of: assume reg-shift of 2 for mrvl,mmp-uart
  serial: 8250_pxa: honor the port number from devicetree
  tty: hvc_xen: Mark expected switch fall-through
  tty: n_gsm: Mark expected switch fall-throughs
  tty: serial: msm_serial: Remove __init from msm_console_setup()
  tty: serial: samsung: Enable baud clock during initialisation
  serial: uartps: Fix stuck ISR if RX disabled with non-empty FIFO
  tty: serial: remove redundant likely annotation
  tty/n_hdlc: mark expected switch fall-through
  serial: 8250_pci: Have ACCES cards that use the four port Pericom PI7C9X7954 chip use the pci_pericom_setup()
  serial: 8250_pci: Fix number of ports for ACCES serial cards
  vt: perform safe console erase in the right order
  tty/nozomi: use pci_iomap instead of ioremap_nocache
  tty/synclink: remove ISA support
  serial: 8250_pci: Replace custom code with pci_match_id()
  serial: max310x: Correction of the initial setting of the MODE1 bits for various supported ICs.
  serial: mps2-uart: Add parentheses around conditional in mps2_uart_shutdown
  ...