1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * MPC85xx setup and early boot code plus other random bits.
5 * Maintained by Kumar Gala (see MAINTAINERS for contact information)
7 * Copyright 2005, 2011-2012 Freescale Semiconductor Inc.
10 #include <linux/stddef.h>
11 #include <linux/kernel.h>
12 #include <linux/init.h>
13 #include <linux/errno.h>
14 #include <linux/reboot.h>
15 #include <linux/pci.h>
16 #include <linux/kdev_t.h>
17 #include <linux/major.h>
18 #include <linux/console.h>
19 #include <linux/delay.h>
20 #include <linux/seq_file.h>
21 #include <linux/initrd.h>
22 #include <linux/interrupt.h>
23 #include <linux/fsl_devices.h>
24 #include <linux/of_platform.h>
26 #include <asm/pgtable.h>
28 #include <linux/atomic.h>
31 #include <asm/machdep.h>
33 #include <asm/pci-bridge.h>
35 #include <mm/mmu_decl.h>
39 #include <asm/i8259.h>
41 #include <sysdev/fsl_soc.h>
42 #include <sysdev/fsl_pci.h>
47 * The CDS board contains an FPGA/CPLD called "Cadmus", which collects
48 * various logic and performs system control functions.
49 * Here is the FPGA/CPLD register map.
52 u8 cm_ver; /* Board version */
53 u8 cm_csr; /* General control/status */
54 u8 cm_rst; /* Reset control */
55 u8 cm_hsclk; /* High speed clock */
56 u8 cm_hsxclk; /* High speed clock extended */
57 u8 cm_led; /* LED data */
58 u8 cm_pci; /* PCI control/status */
59 u8 cm_dma; /* DMA control */
60 u8 res[248]; /* Total 256 bytes */
63 static struct cadmus_reg *cadmus;
67 #define ARCADIA_HOST_BRIDGE_IDSEL 17
68 #define ARCADIA_2ND_BRIDGE_IDSEL 3
70 static int mpc85xx_exclude_device(struct pci_controller *hose,
71 u_char bus, u_char devfn)
73 /* We explicitly do not go past the Tundra 320 Bridge */
74 if ((bus == 1) && (PCI_SLOT(devfn) == ARCADIA_2ND_BRIDGE_IDSEL))
75 return PCIBIOS_DEVICE_NOT_FOUND;
76 if ((bus == 0) && (PCI_SLOT(devfn) == ARCADIA_2ND_BRIDGE_IDSEL))
77 return PCIBIOS_DEVICE_NOT_FOUND;
79 return PCIBIOS_SUCCESSFUL;
82 static int mpc85xx_cds_restart(struct notifier_block *this,
83 unsigned long mode, void *cmd)
88 if ((dev = pci_get_device(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686,
91 /* Use the VIA Super Southbridge to force a PCI reset */
92 pci_read_config_byte(dev, 0x47, &tmp);
93 pci_write_config_byte(dev, 0x47, tmp | 1);
95 /* Flush the outbound PCI write queues */
96 pci_read_config_byte(dev, 0x47, &tmp);
99 * At this point, the hardware reset should have triggered.
100 * However, if it doesn't work for some mysterious reason,
101 * just fall through to the default reset below.
108 * If we can't find the VIA chip (maybe the P2P bridge is
109 * disabled) or the VIA chip reset didn't work, just return
110 * and let default reset sequence happen.
115 static int mpc85xx_cds_restart_register(void)
117 static struct notifier_block restart_handler;
119 restart_handler.notifier_call = mpc85xx_cds_restart;
120 restart_handler.priority = 192;
122 return register_restart_handler(&restart_handler);
124 machine_arch_initcall(mpc85xx_cds, mpc85xx_cds_restart_register);
127 static void __init mpc85xx_cds_pci_irq_fixup(struct pci_dev *dev)
130 if (dev->vendor == PCI_VENDOR_ID_VIA) {
131 switch (dev->device) {
132 case PCI_DEVICE_ID_VIA_82C586_1:
134 * U-Boot does not set the enable bits
135 * for the IDE device. Force them on here.
137 pci_read_config_byte(dev, 0x40, &c);
138 c |= 0x03; /* IDE: Chip Enable Bits */
139 pci_write_config_byte(dev, 0x40, c);
142 * Since only primary interface works, force the
143 * IDE function to standard primary IDE interrupt
147 pci_write_config_byte(dev, PCI_INTERRUPT_LINE, dev->irq);
150 * Force legacy USB interrupt routing
152 case PCI_DEVICE_ID_VIA_82C586_2:
153 /* There are two USB controllers.
154 * Identify them by functon number
156 if (PCI_FUNC(dev->devfn) == 3)
160 pci_write_config_byte(dev, PCI_INTERRUPT_LINE, dev->irq);
167 static void skip_fake_bridge(struct pci_dev *dev)
169 /* Make it an error to skip the fake bridge
170 * in pci_setup_device() in probe.c */
171 dev->hdr_type = 0x7f;
173 DECLARE_PCI_FIXUP_EARLY(0x1957, 0x3fff, skip_fake_bridge);
174 DECLARE_PCI_FIXUP_EARLY(0x3fff, 0x1957, skip_fake_bridge);
175 DECLARE_PCI_FIXUP_EARLY(0xff3f, 0x5719, skip_fake_bridge);
177 #define PCI_DEVICE_ID_IDT_TSI310 0x01a7
180 * Fix Tsi310 PCI-X bridge resource.
181 * Force the bridge to open a window from 0x0000-0x1fff in PCI I/O space.
182 * This allows legacy I/O(i8259, etc) on the VIA southbridge to be accessed.
184 void mpc85xx_cds_fixup_bus(struct pci_bus *bus)
186 struct pci_dev *dev = bus->self;
187 struct resource *res = bus->resource[0];
190 dev->vendor == PCI_VENDOR_ID_IBM &&
191 dev->device == PCI_DEVICE_ID_IDT_TSI310) {
195 res->flags = IORESOURCE_IO;
196 pr_info("mpc85xx_cds: PCI bridge resource fixup applied\n");
197 pr_info("mpc85xx_cds: %pR\n", res);
201 fsl_pcibios_fixup_bus(bus);
204 #ifdef CONFIG_PPC_I8259
205 static void mpc85xx_8259_cascade_handler(struct irq_desc *desc)
207 unsigned int cascade_irq = i8259_irq();
210 /* handle an interrupt from the 8259 */
211 generic_handle_irq(cascade_irq);
213 /* check for any interrupts from the shared IRQ line */
214 handle_fasteoi_irq(desc);
217 static irqreturn_t mpc85xx_8259_cascade_action(int irq, void *dev_id)
221 #endif /* PPC_I8259 */
222 #endif /* CONFIG_PCI */
224 static void __init mpc85xx_cds_pic_init(void)
227 mpic = mpic_alloc(NULL, 0, MPIC_BIG_ENDIAN,
228 0, 256, " OpenPIC ");
229 BUG_ON(mpic == NULL);
233 #if defined(CONFIG_PPC_I8259) && defined(CONFIG_PCI)
234 static int mpc85xx_cds_8259_attach(void)
237 struct device_node *np = NULL;
238 struct device_node *cascade_node = NULL;
241 /* Initialize the i8259 controller */
242 for_each_node_by_type(np, "interrupt-controller")
243 if (of_device_is_compatible(np, "chrp,iic")) {
248 if (cascade_node == NULL) {
249 printk(KERN_DEBUG "Could not find i8259 PIC\n");
253 cascade_irq = irq_of_parse_and_map(cascade_node, 0);
255 printk(KERN_ERR "Failed to map cascade interrupt\n");
259 i8259_init(cascade_node, 0);
260 of_node_put(cascade_node);
263 * Hook the interrupt to make sure desc->action is never NULL.
264 * This is required to ensure that the interrupt does not get
265 * disabled when the last user of the shared IRQ line frees their
268 ret = request_irq(cascade_irq, mpc85xx_8259_cascade_action,
269 IRQF_SHARED | IRQF_NO_THREAD, "8259 cascade",
272 printk(KERN_ERR "Failed to setup cascade interrupt\n");
276 /* Success. Connect our low-level cascade handler. */
277 irq_set_handler(cascade_irq, mpc85xx_8259_cascade_handler);
281 machine_device_initcall(mpc85xx_cds, mpc85xx_cds_8259_attach);
283 #endif /* CONFIG_PPC_I8259 */
285 static void mpc85xx_cds_pci_assign_primary(void)
288 struct device_node *np;
294 * MPC85xx_CDS has ISA bridge but unfortunately there is no
295 * isa node in device tree. We now looking for i8259 node as
296 * a workaround for such a broken device tree. This routine
297 * is for complying to all device trees.
299 np = of_find_node_by_name(NULL, "i8259");
300 while ((fsl_pci_primary = of_get_parent(np))) {
302 np = fsl_pci_primary;
304 if ((of_device_is_compatible(np, "fsl,mpc8540-pci") ||
305 of_device_is_compatible(np, "fsl,mpc8548-pcie")) &&
306 of_device_is_available(np))
313 * Setup the architecture
315 static void __init mpc85xx_cds_setup_arch(void)
317 struct device_node *np;
321 ppc_md.progress("mpc85xx_cds_setup_arch()", 0);
323 np = of_find_compatible_node(NULL, NULL, "fsl,mpc8548cds-fpga");
325 pr_err("Could not find FPGA node.\n");
329 cadmus = of_iomap(np, 0);
332 pr_err("Fail to map FPGA area.\n");
336 if (ppc_md.progress) {
338 cds_pci_slot = ((in_8(&cadmus->cm_csr) >> 6) & 0x3) + 1;
339 snprintf(buf, 40, "CDS Version = 0x%x in slot %d\n",
340 in_8(&cadmus->cm_ver), cds_pci_slot);
341 ppc_md.progress(buf, 0);
345 ppc_md.pci_irq_fixup = mpc85xx_cds_pci_irq_fixup;
346 ppc_md.pci_exclude_device = mpc85xx_exclude_device;
349 mpc85xx_cds_pci_assign_primary();
350 fsl_pci_assign_primary();
353 static void mpc85xx_cds_show_cpuinfo(struct seq_file *m)
355 uint pvid, svid, phid1;
357 pvid = mfspr(SPRN_PVR);
358 svid = mfspr(SPRN_SVR);
360 seq_printf(m, "Vendor\t\t: Freescale Semiconductor\n");
361 seq_printf(m, "Machine\t\t: MPC85xx CDS (0x%x)\n",
362 in_8(&cadmus->cm_ver));
363 seq_printf(m, "PVR\t\t: 0x%x\n", pvid);
364 seq_printf(m, "SVR\t\t: 0x%x\n", svid);
366 /* Display cpu Pll setting */
367 phid1 = mfspr(SPRN_HID1);
368 seq_printf(m, "PLL setting\t: 0x%x\n", ((phid1 >> 24) & 0x3f));
373 * Called very early, device-tree isn't unflattened
375 static int __init mpc85xx_cds_probe(void)
377 return of_machine_is_compatible("MPC85xxCDS");
380 machine_arch_initcall(mpc85xx_cds, mpc85xx_common_publish_devices);
382 define_machine(mpc85xx_cds) {
383 .name = "MPC85xx CDS",
384 .probe = mpc85xx_cds_probe,
385 .setup_arch = mpc85xx_cds_setup_arch,
386 .init_IRQ = mpc85xx_cds_pic_init,
387 .show_cpuinfo = mpc85xx_cds_show_cpuinfo,
388 .get_irq = mpic_get_irq,
390 .pcibios_fixup_bus = mpc85xx_cds_fixup_bus,
391 .pcibios_fixup_phb = fsl_pcibios_fixup_phb,
393 .calibrate_decr = generic_calibrate_decr,
394 .progress = udbg_progress,