arch/arm64/boot/dts/qcom/sc7180-trogdor-lazor.dtsi

   1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
   2 /*
   3  * Google Lazor board device tree source
   4  *
   5  * Copyright 2020 Google LLC.
   6  */
   7
   8 /* This file must be included after sc7180-trogdor.dtsi */
   9 #include <arm/cros-ec-keyboard.dtsi>
  10
  11 &ap_sar_sensor {
  12         semtech,cs0-ground;
  13         semtech,combined-sensors = <3>;
  14         semtech,resolution = "fine";
  15         semtech,startup-sensor = <0>;
  16         semtech,proxraw-strength = <8>;
  17         semtech,avg-pos-strength = <64>;
  18 };
  19
  20 &ap_tp_i2c {
  21         status = "okay";
  22 };
  23
  24 /*
  25  * Lazor is stuffed with a 47k NTC as charger thermistor which currently is
  26  * not supported by the PM6150 ADC driver. Disable the charger thermal zone
  27  * to avoid using bogus temperature values.
  28  */
  29 &charger_thermal {
  30         status = "disabled";
  31 };
  32
  33 ap_ts_pen_1v8: &i2c4 {
  34         status = "okay";
  35         clock-frequency = <400000>;
  36
  37         ap_ts: touchscreen@10 {
  38                 compatible = "hid-over-i2c";
  39                 reg = <0x10>;
  40                 pinctrl-names = "default";
  41                 pinctrl-0 = <&ts_int_l>, <&ts_reset_l>;
  42
  43                 interrupt-parent = <&tlmm>;
  44                 interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
  45
  46                 post-power-on-delay-ms = <20>;
  47                 hid-descr-addr = <0x0001>;
  48
  49                 vdd-supply = <&pp3300_ts>;
  50         };
  51 };
  52
  53 &panel {
  54         compatible = "boe,nv133fhm-n62";
  55 };
  56
  57 &pm6150_adc {
  58         status = "disabled";
  59
  60         /delete-node/ charger-thermistor@4f;
  61 };
  62
  63 &pm6150_adc_tm {
  64         status = "disabled";
  65
  66         /delete-node/ charger-thermistor@0;
  67 };
  68
  69 &trackpad {
  70         interrupts = <58 IRQ_TYPE_EDGE_FALLING>;
  71 };
  72
  73 &wifi {
  74         qcom,ath10k-calibration-variant = "GO_LAZOR";
  75 };
  76
  77 /* PINCTRL - modifications to sc7180-trogdor.dtsi */
  78
  79 &trackpad_int_1v8_odl {
  80         pinmux {
  81                 pins = "gpio58";
  82         };
  83
  84         pinconf {
  85                 pins = "gpio58";
  86         };
  87 };
  88
  89 &ts_reset_l {
  90         pinconf {
  91                 /* This pin is not connected on -rev0, pull up to park. */
  92                 /delete-property/bias-disable;
  93                 bias-pull-up;
  94         };
  95 };
  96
  97 /* PINCTRL - board-specific pinctrl */
  98
  99 &tlmm {
 100         gpio-line-names = "ESIM_MISO",
 101                           "ESIM_MOSI",
 102                           "ESIM_CLK",
 103                           "ESIM_CS_L",
 104                           "",
 105                           "",
 106                           "AP_TP_I2C_SDA",
 107                           "AP_TP_I2C_SCL",
 108                           "TS_RESET_L",
 109                           "TS_INT_L",
 110                           "",
 111                           "EDP_BRIJ_IRQ",
 112                           "AP_EDP_BKLTEN",
 113                           "AP_RAM_ID2",
 114                           "",
 115                           "EDP_BRIJ_I2C_SDA",
 116                           "EDP_BRIJ_I2C_SCL",
 117                           "HUB_RST_L",
 118                           "",
 119                           "AP_RAM_ID1",
 120                           "AP_SKU_ID2",
 121                           "",
 122                           "",
 123                           "AMP_EN",
 124                           "P_SENSOR_INT_L",
 125                           "AP_SAR_SENSOR_SDA",
 126                           "AP_SAR_SENSOR_SCL",
 127                           "",
 128                           "HP_IRQ",
 129                           "AP_RAM_ID0",
 130                           "EN_PP3300_DX_EDP",
 131                           "AP_BRD_ID2",
 132                           "BRIJ_SUSPEND",
 133                           "AP_BRD_ID0",
 134                           "AP_H1_SPI_MISO",
 135                           "AP_H1_SPI_MOSI",
 136                           "AP_H1_SPI_CLK",
 137                           "AP_H1_SPI_CS_L",
 138                           "",
 139                           "",
 140                           "",
 141                           "",
 142                           "H1_AP_INT_ODL",
 143                           "",
 144                           "UART_AP_TX_DBG_RX",
 145                           "UART_DBG_TX_AP_RX",
 146                           "HP_I2C_SDA",
 147                           "HP_I2C_SCL",
 148                           "FORCED_USB_BOOT",
 149                           "",
 150                           "",
 151                           "AMP_DIN",
 152                           "",
 153                           "HP_BCLK",
 154                           "HP_LRCLK",
 155                           "HP_DOUT",
 156                           "HP_DIN",
 157                           "HP_MCLK",
 158                           "TRACKPAD_INT_1V8_ODL",
 159                           "AP_EC_SPI_MISO",
 160                           "AP_EC_SPI_MOSI",
 161                           "AP_EC_SPI_CLK",
 162                           "AP_EC_SPI_CS_L",
 163                           "AP_SPI_CLK",
 164                           "AP_SPI_MOSI",
 165                           "AP_SPI_MISO",
 166                           /*
 167                            * AP_FLASH_WP_L is crossystem ABI. Schematics
 168                            * call it BIOS_FLASH_WP_L.
 169                            */
 170                           "AP_FLASH_WP_L",
 171                           "DBG_SPI_HOLD_L",
 172                           "AP_SPI_CS0_L",
 173                           "",
 174                           "",
 175                           "",
 176                           "",
 177                           "",
 178                           "",
 179                           "UIM2_DATA",
 180                           "UIM2_CLK",
 181                           "UIM2_RST",
 182                           "UIM2_PRESENT",
 183                           "UIM1_DATA",
 184                           "UIM1_CLK",
 185                           "UIM1_RST",
 186                           "",
 187                           "EN_PP3300_CODEC",
 188                           "EN_PP3300_HUB",
 189                           "",
 190                           "",
 191                           "",
 192                           "",
 193                           "",
 194                           "AP_SKU_ID1",
 195                           "AP_RST_REQ",
 196                           "",
 197                           "AP_BRD_ID1",
 198                           "AP_EC_INT_L",
 199                           "",
 200                           "",
 201                           "",
 202                           "",
 203                           "",
 204                           "",
 205                           "",
 206                           "",
 207                           "",
 208                           "EDP_BRIJ_EN",
 209                           "AP_SKU_ID0",
 210                           "",
 211                           "",
 212                           "",
 213                           "",
 214                           "",
 215                           "",
 216                           "",
 217                           "",
 218                           "",
 219                           "AP_TS_PEN_I2C_SDA",
 220                           "AP_TS_PEN_I2C_SCL",
 221                           "DP_HOT_PLUG_DET",
 222                           "EC_IN_RW_ODL";
 223 };